PLGA from PolySciTech used in microfluidic nanoparticle generation method development

 

Nanoparticles are generally created by mixing polymer dissolved in a solvent with a non-solvent for the polymer such that the polymer precipitates out into nanosized spheres. This can be achieved by a variety of methods though microfluidics enables reliable control of the mixing conditions for good reproducibility. Recently researchers at Assiut University, Badr University in Cairo (Egypt), and American University of Sharjah (UAE) used PLGA (AP154) from PolySciTech (www.polyscitech.com) to optimize nanoparticle generation using a microfluidic system. This research holds promise to improve the rapid and robust generation of nanoparticles for drug-delivery. Read more: Abdelkarim, Mahmoud, Noura H. Abd Ellah, Mahmoud Elsabahy, Mohamed Abdelgawad, and Sara A. Abouelmagd. "Microchannel geometry vs flow parameters for controlling nanoprecipitation of polymeric nanoparticles." Colloids and Surfaces A: Physicochemical and Engineering Aspects (2020): 125774. https://www.sciencedirect.com/science/article/pii/S0927775720313674

“Abstract: Channel-based microfluidics was proven to be a helpful platform for reproducible preparation of nanoparticles (NPs), where controlled mixing of fluids allows homogeneous and tuned process of NPs formation. Nanoprecipitation is a popular method for polymeric NPs formation based on controlled precipitation of a polymer upon mixing of two miscible solvents. Conventionally, flow rate, flow rate ratio and polymer concentration have been utilized to control NPs size and polydispersity. However, minimum attention has been given to the effect of channel geometry on nanoprecipitation process. In our study, we investigated the effect of channel geometry and design on the size and polydispersity index (PDI) of poly (lactic-co-glycolic) acid (PLGA) NPs. Ten different designs with varied channel length, aspect ratio, number of interfaces and channel curvature were fabricated and tested. These variations were introduced to modify the diffusion rate, the interface area or to introduce Dean flow, all of which will change the mixing time (Tmix). The effects of these variations were compared to that of different flow parameters. Change in channel length did not have a significant effect on particle size. However, increasing the diffusion area and reducing (Tmix) significantly reduced NPs’ size. Moreover, when curvature was introduced into the channel, mixing was enhanced, and particle size was decreased in a manner dependent on the velocity of the generated Dean flow. While different flow parameters continue to be the main approach for adjusting NPs properties, we demonstrate that channel geometry modification enables tuning of NPs’ size using simple designs that can be easily adapted. Keywords: Microfluidics Nanoprecipitation PLGA Polymeric nanoparticles Hydrodynamic focusing”